b'Light Weight Belting Specification SheetCatalog # 204 Pulley Diameter, MinimumItem number: 30020Description:ZL Brown Nitrile Rough Top x FS FDAInternational Designation:Brown Nitrile Rough Top x FS A) Normal Flex (76.20 mm) 3.0000 inB) Back Flex (152.40 mm) 6.0000 inConstruction:Compound Top Cover Brown Nit Belt Strength:Top Cover Thickness (in) (4.80 mm) 0.1890 in Pull for 1% Elongation (26 N/mm) 150 lbs/sq inTop Cover Description RoughtopTop Cover Shore 60 Splice Instructions:Compound Bottom Cover Brown Nit Foil NoBottom Cover Thickness (in) (0.00 mm) 0.0000 in Splice Process n/aBottom Cover Description Friction Surface Press Temperature (F) 0 FBottom Cover Shore N/A Press Pressure (psi) 0 lbs/sq inNumber of Plies 1 Note:Listed above is a guideline only.Every vulcanizer is different and will Anti Static No show different results.We recommend that you do a test splice with your press before attempting the actual belt splice.Overall Gauge (in) (6.35 mm) 0.2500 inUnit Weight- lb/PIW 0.0908 lbs/PIWMaterial Between Plies Spiral Polyester Other:Maximum Width (in) 72 in Cross Rigid YesTemperature Range (F)- High 250 F High Heat NoTemperature Range (F)- Low 0 F Impression Top YesOil Resistant YesFire Resistant NoFDA Approved YesSpecial Characteristics:ZipLink is a breakthrough in belting design that combines time tested rubber cover materials with a structured spiral mesh than can be easily spliced at any length into a continuous belt without the need for special tools. ZipLink\'s construction eliminates points of weakness because there is no loss of strength at the splice area. The recommended working tension of all ZipLink belts is 150lbs/in with very little stretch to the polyester mesh. This belt is stocked at 72" wide and can easily ship within 3 working days.*****All Values are nominal and subject to change without notice.*****'